Имя: Дмитрий
Сообщения: 1469
Откуда: Мытищи М.О.
Модератор: М: Автомобили
Цитата:I have installed WAI kit about an year ago (30tkm). Water/meth consumptions has been something like 3l/600km. Today while I was checking my timing(was still spot on!) I took also intake manifold off just to check the valves. Here is couple pics what I found...
50% cleaned
99% cleaned
So my conclusion is, if you have all ready dirty intake port WAI kit won't help you to clean the ports. WAI will make the engine perform better, but carbon/tar is still there choking the air flow...
Цитата:+1 Jykke!
The WAI kit protects the engine when it is clean, but it cannot clean an engine that is already clogged heavily.
Luis, this is one of the recommended methods for introducing Seafoam.
If I remember well, the instructions said that you should do this procedure, then turn off your engine and let Seafoam soak the intake manifold. After 30 minutes start the car again and you are done. You need to change the engine oil after that, too as Seafoam is very corrosive.
Сейчас этот форум просматривают: нет зарегистрированных пользователей и гости: 0